Declaration Of Conformity; I.p. Approval Confi Rmation - DeWalt P3X Manual

English
9

Declaration of Conformity

In accordance with Machinery
Directive
2006/42/EC
Product: Nail Setting Tool
Type: D WALT DDF213000
E
The designated product corresponds to the
provisions of Machinery Directive 2006/42/EC as
well as the harmonized EN 15895 standard.
The signatory is responsible for compiling the
technical documents and submits this declaration
on behalf of D WALT.
E
For more information, please contact D
the following address. For additional addresses,
please refer to the backside of this instruction
manual.
Colin Earl
Idstein, 22. April 2014
Vice President HTF
Construction and DIY Europe
D WALT, Richard-Klinger-Straße 11
E
D-65510, Idstein, Germany
44
10 C.I.P. Approval
Confi rmation
The D
E
system-tested. The square approval symbol
contains the registered approval number „PTB
S 823". With this, D
device complies with the approved type.
Inadmissible defects that are detected during
operation have to be reported to the authority
responsible for the approval (PTB Braunschweig)
as well as the Permanent International
Commission (Permanent International
Commission, Avenue de la Renaissance 30,
B-1000 Brussels, Belgium).
WALT at
E
Approval of the technical unit consisting of
type-approved tool and specifi ed cartridge in
a magazine is documented by system approval.
The test certifi cate numbers of the respective
system approvals are listed in the following
table:
D WALT
E
Magazined cartridge
stripes for P3X
D WALT 6.3/10
E
(.25 cal.), gelb
D WALT 6.3/10
E
(.25 cal.), rot
WALT P3X device is type-approved and
WALT guarantees that the
E
PTB
Test certifi cate
number of the system
approval
PTB Sy 823 DW 14
PTB Sy 824 DW 16