Removing The Fpem From The Cisco Cbr Chassis - Cisco cBR Series Manual

Figure 4: Removing the Power Module
Step 5
Place the removed Power Module in an antistatic bag.
What to do next
• Replace the Power Module
• Position the front power entry bezel on the chassis. Insert and tighten the two screws using a 3/16" flat-blade torque screwdriver
with a torque of 5-7 in-lb (0.56-0.79 Nm) to secure the bezel.

Removing the FPEM from the Cisco cBR Chassis

Before you begin
• For an AC-powered Cisco cBR chassis,
For an DC-powered Cisco cBR chassis,
• Attach an ESD-preventive wrist strap to your wrist and connect the other end to the grounding lug connected to the chassis.
6
(if required).
remove the AC power
remove the DC power
connections.
connections.