Benchtop jointer with spiral cutterhead (28 pages)
Summary of Contents for Wen 61705
Page 1
WENPRODUCTS.COM IMPORTANT: Your new tool has been engineered and manufactured to WEN’s highest standards for dependability, ease of operation, and operator safety. When properly cared for, this product will supply you years of rugged, trouble-free performance. Pay close attention to the rules for safe operation, warnings, and cautions.
INTRODUCTION Thanks for purchasing the WEN crown stapler. We know you are excited to put your tool to work, but first, please take a moment to read through the manual. Safe operation of this tool requires that you read and understand this operator’s manual and all the labels affixed to the tool. This manual provides information regarding potential safety concerns, as well as helpful assembly and operating instructions for your tool.
GENERAL SAFETY RULES Safety is a combination of common sense, staying alert, and knowing how your item works. SAVE THESE SAFETY INSTRUCTIONS. WARNING: Read and understand all warnings, cautions and operating instructions before using this tool. Failure to follow all instructions listed below may result in personal injury and tool damage.
Page 5
GENERAL SAFETY RULES 4. Prevent unintentional starting. Ensure the switch is in the off-position before connecting to power source and/or battery pack, picking up or carrying the tool. Carrying power tools with your finger on the switch or energizing power tools that have the switch on invites accidents. 5.
SPECIFIC RULES FOR STAPLERS WARNING: To avoid mistakes and serious injury, do not use your tool until the following steps have been read and understood. 1. AIR PRESSURE • Use air pressure that is compatible with the ratings on the nameplate of the tool. •...
Page 7
SPECIFIC RULES FOR STAPLERS 10. DO NOT REMOVE, tamper with, or otherwise cause the tool or trigger to become inoperable. Do not tape or tie the trigger in the ON position. Make daily inspections for free movement of the trigger. Uncontrolled discharge may result.
KNOW YOUR STAPLER Exhaust Cover Air Inlet Magazine Lock Magazine Trigger PACKING LIST Check your packing list against the diagram below. If any part is damaged or missing, please contact our customer service at (800) 232-1195, M-F 8-5 CST or email us at techsupport@wenproducts.com. Crown Stapler 4 mm hex wrench 3 mm hex wrench...
OPERATION LUBRICATION This tool requires lubrication before each use (especially the first use). If an in-line oiler is used, manual lubrication through the air inlet is not required. NOTE: the work surface can become damaged by excessive lubrication. Proper lubrication is the owner’s responsibility. Failure to lubricate the tool properly will drastically shorten the life of the tool and void the warranty.
Page 10
OPERATION LOADING THE STAPLER (FIG. 3) WARNING: TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION, BEFORE LOADING: • You and other people in the work area must wear ANSI-approved safety goggles with side shields. • Release the trigger. • Connect the tool to a compressed air source. •...
Dispose of the remaining staple strip; it may be bent or damaged in some other way. 4. If you are unable to clear the staple jam using the method prescribed above, call WEN Customer Service at 1-800-232-1195, M-F, 8-5 CST for assistance, or email techsupport@wenproducts.com.
Page 13
EXPLODED VIEW & PARTS LIST MODEL DESCRIPTION MODEL DESCRIPTION 61702-001 Screw 61702-030 Screw 61705-002 Cylinder Cap 61702-031 Plate 61702-002a Exhaust Deflector 61702-032 Screw 61702-003 Gasket 61702-033 Drive Guide 61702-004 Seal 61702-034 Spring Pin 2 x 10 61702-005 O-Ring 15.7 x 2...
WARRANTY STATEMENT WEN Products is committed to building tools that are dependable for years. Our warranties are consistent with this commitment and our dedication to quality. LIMITED WARRANTY OF WEN PRODUCTS FOR HOME USE GREAT LAKES TECHNOLOGIES, LLC (“Seller”) warrants to the original purchaser only, that all WEN consumer power tools will be free from defects in material or workmanship during personal use for a period of two (2) years used for professional or commercial use.
Need help?
Do you have a question about the 61705 and is the answer not in the manual?
Questions and answers