Service Guide To A Successful Installation - Fetco CBS-2111XTS Users Manual And Operator Instructions

Extractor touch screen models

Hide thumbs

Table of Contents

General:

1. If not installed correctly by qualified personnel, the brewer will not operate properly and damage may result.

2. Utilize only qualified beverage equipment service technicians for service and installation.

3. Always have an empty dispenser under sprayhead of all coffee brewing equipment-including when at idle

4. Damages resulting from improper installation are not covered by the warranty, and will void the warranty.

5. Optional Hot Water Service Faucet is separate. See Page 22 for installation instructions. Install before startup.

Below are the key points to consider before installation:

Electrical:

1. All CBS_Series brewers require an electrical ground wire. Installation without grounding is dangerous.

2. Note Equipotentiality Terminal, if present,

of equipment or of a system to the same potential, not necessarily being the earth (ground) potential, e.g. for local bonding.)

3. Verify voltages, polarity, circuits, and circuit breaker access before attaching equipment.

4. Brewers in this series wire differently in regards to a neutral wire. Review the wire diagrams.

5. The electrical diagram is located in the Users Guide and online at www.fetco.com.

6. Make sure of the tight grounding of the equipment and use the external ground bolt.

7. The installation must comply with applicable federal, state, and local codes having jurisdiction at your location.

Check with your local inspectors to determine what codes will apply.

Plumbing:

1. North America: All installations must comply with applicable federal, state, or local plumbing codes.

2. All Others: The water and waste piping and connections shall comply with the International Plumbing Code 2003,

International Code Council (ICC), or to the Uniform Plumbing Code 2003 (IAPMO).

3. Use an inline water filter for all beverage equipment.

4. Install the filter unit after a water shutoff valve and in a position to facilitate filter replacement.

5. The water line and newly installed filter cartage must be flushed thoroughly prior to connecting it to the brewer to

prevent debris from contaminating the machine.

6. Verify that the water line will provide a flow rate of at least 1½gpm/(5.7lpm) per minute and the water pressure is

between 20-75 psig (138-517kPa) before making any connections.

7. Use a wrench on the factory fitting when connecting the incoming water line. This will reduce stress on the internal

connections and reduce the possibility of leaks developing after the install has been completed

8. Install a backflow prevention device. Most municipalities require a recognized backflow preventer.

Usable on all hot beverage and cold beverage equipment is a WATTS® SD-2 or SD-3.

WATTS spring loaded double check valve models are accepted by most zoning authorities.

The check valve should be as close to the water supply inlet of the beverage equipment as possible.

Tank Drain

The water tank must be drained before maintenance procedures, and when the unit is to be relocated or shipped

1. Disconnect power to unit.

2. Move the unit near a sink or obtain a container large enough to hold four gallons of water and a hose clamp.

Note that the tank may hold more than four gallons and that the drain line will be clamped to empty the container.

3. NOTE: Multiple buckets may be needed during the draining, see tank volumes below

4. Remove the tank cover and allow the tank to cool to a safe temperature

5. The tank drain is located on the back of the unit. Turn the drain plug one-quarter turn in either direction

6. Pull the plug out far enough to expose the silicone tube

7. Using pliers loosen the hose clamp and move it back over the tube.

8. Crimp the tube an inch or two away from the drain plug to prevent water from flowing.

9. Use the other hand to pull the drain plug out of the tube.

10. Release the crimped tube and allow the water to flow into the sink or container.

Go to fetco.com for the latest versions of all information