Service Guide To A Successful Installation; Wiring Diagrams - Fetco CBS-2100XTS Users Manual And Operator Instructions

Extractor touch screen

Hide thumbs

Table of Contents

General:

1. If not installed correctly by qualified personnel, the brewer will not operate properly and damage may result

2. Select and install legs. Leg sets are shipped inside the brew basket

3. Some FETCO CBS-2100XTS series equipment have user configurable dispenser locator-see instructions.

4. Utilize only qualified beverage equipment service technicians for service and installation.

5. Always have an empty dispenser under sprayhead of all coffee brewing equipment-including when at idle

6. Damages resulting from improper installation are not covered by the warranty, and will void the warranty.

Below are the key points to consider before installation:

Electrical:

1. All CBS_Series brewers require an electrical ground wire. Installation without grounding is dangerous.

2. Note Equipotentiality Terminal, if present,

of equipment or of a system to the same potential, not necessarily being the earth (ground) potential, e.g. for local bonding.)

3. Verify voltages, polarity, circuits, and circuit breaker access before attaching equipment.

4. Brewers in this series wire differently in regards to a nuatral wire. Review the wire diagrams.

5. The electrical diagram is located in the Users Guide and online at www.fetco.com.

6. Make sure of the tight grounding of the equipment and use the external ground bolt.

7. The installation must comply with applicable federal, state, and local codes having jurisdiction at your location.

Check with your local inspectors to determine what codes will apply.

CBS-2141XTS From Factory

120 volt models

NEMA PLUG CONFIGURATION

NEMA 5-15P

NEMA 5-20P

All CBS 2141XTS

SKU E214171, E214172; E214173

As supplied from factory

Go to fetco.com for the latest version of all information Part B