Table of Contents
Advertisement
(2) Hold the connection cord and the harness (LED)
using the wire holder of the harness guard assem-
bly.
(3) Attach the ferrite clamp of the supplied accesso-
ries to the connection cord as shown in the figure.
Ferrite clamp
(Supplied accessory)
Connection cord
50 to 60 mm
Harness (LED)
13. Reinstall the plug-in boards.
(1) Insert the DPR-155/229 board, EPR-1 board, and
VPR-64 board to the original slot. Push simulta-
neously down the two eject levers of the each
board to firmly connect it to the motherboard.
EPR-1 board
Eject lever
DPR-155/229 board
BKMW-E3000
Harness guard assembly
Wire holder
Eject lever
VPR-64 board
(2) Insert the VN-13 board assembly into the slot No.
8 while lifting up the connection cord and the
harness (LED). Push simultaneously down the two
eject levers of the each board to firmly connect it
to the motherboard.
n
In the case of Installing Pattern [C]:
Check that Bit-4 of the switch S101 is set to ON
(upper side).
VN-13 board assembly
Eject lever
14. Connect the harnesses of the supplied accessories.
(1) Connect the harness (LED) to the connector
CN1102 on the VN-13 board.
(2) Connect the connection cord to the connector
CN1103 on the VN-13 board, and tuck the ferrite
clamp between the boards.
Ferrite clamp
Harness (LED)
VN-13 board
CN1102
Eject lever
Connection
cord
Harness
(LED)
Connection cord
CN1103
1-13 (E)
Advertisement
Table of Contents
