Table of Contents
Advertisement
n
In the case of Installing Pattern [C]:
The following steps (3) and (4) are not required. (Proceed
to Step 15.)
(3) Bend the harness (EPR-VN) of the supplied
accessories as shown in the Fig. 1.
(4) Set the ferrite cores to the shield plate side, and
tuck the harness between the boards. And then
connect it to the connectors CN5 on the VN-13
board and CN2 on the IF-886 board. (Refer to
Fig. 2)
n
Be sure to open the space between the edge of the
shield plate and the harness (EPR-VN) as shown
in the figure.
Fig. 1
10 mm
70 mm
EPR-1 board
IF-886 board
CN2
Fig. 2
Harness (EPR-VN)
Space
EPR-1 board
IF-886 board
1-14 (E)
Harness (EPR-VN)
(Supplied accessory)
65 mm
VN-13 board
CN5
VN-13 board
Ferrite cores
Shield plate
15. Arrange the coaxial cables as shown in the figure, and
reattach the cable protector in the arrow direction.
Cable protector
(When there is
the coaxial cables
disconnected.
16. Reattach the upper lid (rear) assembly of the VTR, and
tighten the two screws (with stopper).
or
BKMW-E3000
Advertisement
Table of Contents
