Connections For A Debugging Network - Sony DECR-1000 A Instruction Manual

Connections for a debugging network

Connections for a debugging network
Items required for connection
The following items are necessary in order to set
up the debugging network for this unit:
• Reference tool (this unit)
• Ethernet cables × 2
• Ethernet hub
• AV MULTI 480i- or HDMI 480p-compatible
display
• Host PC
Caution
Under the factory default settings, an analog RGB- or PAL-
compatible display will not display the initial settings for the
debugging network.
Information required for setup
The following information is required to set up the
unit.
• Availability of a DHCP server
• IP address
• Subnet mask
• IP address for the default gateway
For information on the configuration of the
network you will be connecting the unit to, contact
the network administrator.
Connection setup
If there is no DHCP server on the network
Create a local area network using the unit and the
development PC. Under this network, the
following static IP address will be assigned to the
unit automatically.
IP address: 192.168.0.2
Subnet mask: 255.255.255.0
Caution
• The IP address and subnet mask settings are factory default
values. If the unit's network settings change, these settings
will also change accordingly.
• If connecting to a network with settings that are different
from the above, first use a local area network to confirm the
connection following the procedures contained in this
section, and then proceed with adjusting the unit's network
settings. For information on the unit's network settings, see
"Setting up with the administration tool" (t page 25). After
adjusting the network settings for the unit and the
development PC, connect the two components to an existing
Ethernet hub on the network.
If there is a DHCP server on the network
Connect the unit and the development PC with the
DHCP client software to an Ethernet hub on the
network. In this case, setting such as the IP address
and subnet mask will be obtained automatically
once the power is on. Depending on the DHCP
server's settings, settings such as those for the
DNS server or default gateway may also be set
automatically. To determine which settings are
obtained automatically, contact the network
administrator.
Making connections
1
Connect the unit to the hub with the
Ethernet cable.
2
Connect the hub to the host PC with the
Ethernet cable.
Setting up the development PC
Set up the development PC before setting up the
unit.
If there is no DHCP server on the network
1
Turn on the development PC.
2
Set up the network for the development
PC.
Set the following information.
IP address: 192.168.0.1
Subnet mask: 255.255.255.0
If there is a DHCP server on the network
1
Turn on the development PC.
Connections for a debugging network
23