Storage And Maintenance - ZAPTEC HOME User Manual

authenticate the user with the charging station if the installation/charging station has been activated
with authentication. Charging will start automatically when charging power is available.
Red light:
• Disconnect the charging cable. Reconnect the charging cable if the status indicator light turns
white. If charging does not start and the light turns red again, this could indicate a potential fault
in the charging cable or vehicle.
Red flashing light:
• Disconnect the charging cable. Reconnect the charging cable if the status indicator light turns
white. If charging does not start and the light turns red again, this could indicate a potential fault
in the charging cable or vehicle.
• Check that your user profile has been assigned access to this installation by the owner in ZAPTEC
Portal.
• A flashing red light every 30 seconds means that it is not activated in ZAPTEC Portal. Contact
your electrician/installer.
• If this does not work, make a note of the serial number of the charging station and contact your
dealer/installer for assistance. The serial number location is shown in the illustration.
A yellow light will flash if the charging station has been disconnected from the electricity network
i
and it will take 1-2 minutes before the charging station boots up again.

Storage and maintenance

The product must be stored in a dry room with stable temperatures. The protective cover should
always be on if the product is not in use.
The following periodic maintenance is recommended:
• Wipe down the charging station using a damp cloth.
221.3
• Check that the charging connector is free of foreign bodies.
Serial number e.g.
ZCH123456
EN
1 1