Wiznet WIZ127SR User Manual page 29

Window"
② Modify the settings according to your needs
③ Click the "Setting" button to apply your settings
④ The module will be initialized by a re-booting process
⑤ To verify your settings, please click 'Search' button and view your new settings
3) Firmware Upload
Firmware will be uploaded through your network. The Procedure of Firmware upload is
explained details in "5. How to upload a new
4) Factory Reset
All setting value is initialized to factory default, if you click the "Factory Reset" button.
For factory default value of WIZ127SR, refer to
5) Exit
Close the configuration tool program window.
6) Search Window
If you click the "Search" button, all the MAC addresses on the same subnet will be displayed.
7) Device network settings
Static: "Using the follow IP Address" is an option for setting WIZ127SR module's IP with static
IP address..
Select a MAC address which you want to set as static IP in the "Search Window".
1.
Check "Using the follow IP address".
2.
The "Device IP, Gateway, Subnet mask, DNS server" box will be enabled, and then input
3.
address in those fields.
Click the "Setting" button to apply your configurations.
4.
DHCP: Select "Get IP address from DHCP server" option to use the DHCP mode.
Select the MAC address on the "Search Window".
1.
Check "Get IP address from DHCP server" and click the 'Setting' button.
2.
3. A module will acquire network information from the DHCP server. (Should wait a moment
to acquire network information from the DHCP server.)
When a module on the "Search Window" is selected, the IP address, Subnet mask and
4.
Gateway are displayed. If the module could not acquire the network information from the
DHCP server, the IP address, the Gateway Address and the Subnet mask will be
initialized as 0.0.0.0.
IP Address Information
WIZ127SR User's Manual
firmware"
"4.4 Factory Default Value of
WIZ127SR"
23