Advertisement
I Checking and Adjusting Document Skew
4582U003AA
4582U006AC
4582U007AC
1. Place the chart furnished with the Document
Feeder in the document feeding tray (with
the side having an arrow facing up).
2. Set up the following functions:
• Select the tray in which A4 crosswise or Let-
ter crosswise paper is loaded.
• 1-sided original
1-side copy
3. Press the Start key.
4. Check in which direction, A or B, the image
tilts on the copy fed out of the machine.
Specifications: Tilt 3 mm max.
*
If the image tilts more than the specifications,
perform the following steps to make the
adjustment.
5. Loosen the two front screws on the right
hinge.
If the gap A is wider than gap B, move the
Document Feeder toward the front.
If the gap B is wider than gap A, move the
Document Feeder toward the rear.
NOTE
Do not move the Document Feeder to the
frontmost or leftmost position.
6. Tighten the two screws.
7. Make the copy and check again.
DF-601
I Checking and Adjusting the Document Feeding Tray Reference Posi-
tion
4582U003AA
<Metric Areas for standard line>
A
B
<Inch Areas for standard line>
A
B
4582U005AC
– 3 –
1. Place the chart furnished with the Document
Feeder in the document feeding tray (with
the side having an arrow facing up).
2. Set up the following functions:
• Select the tray in which A4 crosswise or Let-
ter crosswise paper is loaded.
• 1-sided original
1-side copy
3. Press the Start key.
4. Fold the copy in half.
5. With reference to the crease, check to see if
the arrow is on the side of A or B.
Specifications: ±2 mm from the center
*
If the deviation falls outside the specified
range, use the following procedure to make
an adjustment.
6. Loosen the screw (two on the front side and
three on the backside) on the document
feeding tray.
If the crease deviates on the side of A, move
the tray to the front.
If the crease deviates on the side of B, move
the tray to the rear.
7. Tighten the five screws.
8. Make the copy and check again.
Advertisement
