Connecting The Dc Power And Power Button - FabiaTech Fanless Series User Manual

FabiaTech Corporation

Connecting the DC Power and Power Button

Power is supplied through an external AC/DC power adapter or power DC In. Take
reference to the technical specification section for information about AC/DC
power input voltage. See following figure.
DC-Power Jack: Plug External AC/DC power adapter into DC-jack (2) plug the
1.
cable into hole (1), then pull up the end of the cable (3).
DC Power Connector: Use external 3-pin detachable terminal block. The DC-IN
2.
SYS is +12~24V for FX5637 system power requirement, and DC-IN +12V CARD is
for FX5637S1/S2- FB4744 PCIE or FB4745 PCI/PCIE Riser Card, which connects to
CN1 connector +12V input from system board through CN9. If insert the
expansion card power requirement up to +12V/1.2A (Refer expansion card
power specification) you can use external DC power supply connection to
DC-IN +12V CARD terminal block.
Power Button & Reset Push Button: Pushing the Power button one time will
3.
switch the system on and off. And Reset push button is the switch for system
reset. Push and release the reset button will make hardware reset system and
restart booting the system.
Power button: On/Off
DC +12V~+24V, 75VA minimum
DC IN
SYS CARD
-
+12~24V +12V
Terminal Block
Reset Push Button: Restart
24