Menu / Query Parameters - Pentair eco select ULTRATEMP HX Series Owner's Manual

Menu / Query Parameters

1. On main interface screen, press
buttons to navigate to each parameter. Refer to table below for a list of all parameters.
DOWN
(DEFROST)
2. Press at any time to confirm settings and go back to main interface.
ON/OFF
(UNLOCK)
Code Parameter Name
A1 Coil temp
A2 Compressor suction
gas temp
A3 Compressor exhaust
gas temp
A4 Ambient air temp
A5 Outlet water temp
A6 Compressor current Displays the compressor current (3-Phase
A7 Opening of the EEV
E1-E6 Error code display
to enter into parameter query menu. Press
MENU
(SET)
Description
This is the evaporator coil temperature.
This is the refrigerant gas temperature at the
inlet of the compressor.
This is the refrigerant gas temperature at the
outlet of the compressor.
This is the ambient (atmospheric) tempera-
ture.
This is the water temperature at the outlet of
the heat pump (return to pool).
units only).
Opening angle of the EEV (Electronic Expan-
sion Valve).
Displays up to 6 error codes, in the unlikely
event or malfunction. Refer to Troubleshoot-
ing section for error code details.
Page 21
Configuration
and
UP
(HEAT/COOL)
Typical Range
(-10)-15 C (Heat)
0
35-48 C (Cool)
0
(-10)-15 C (Heat)
0
10-25 C (Cool)
0
40-80 C (Heat)
0
60-95 C (Cool)
0
(-10)-45 C
0
5-40 C
0
5-10A
10-60
None