Maintenance And Cleaning; Service - Berner Architectural High Performance 10 Installation & Maintenance Instructions Manual

VIII. MAINTENANCE & CLEANING
CAUTION: ELECTRIC SHOCK HAZARD Disconnect power
whenever servicing unit. More than one disconnect may be
required to de-energize unit.
Keep your air curtain operating at peak efficiency by cleaning
the blower wheels, motor(s) and intake grill. Buildup of dust on
the blower wheels can cause vibration, noise and excessive wear
on the motor bearings. The frequency of cleaning will depend
on the environment where the unit is operating.
Dirty, dusty or greasy environments could require a cleaning
schedule of once every two months. If the environment is not
that dirty, the unit(s) should be scheduled for cleaning a mini-
mum of once every (6) months.
A. PERFORMING PREVENTIVE MAINTENANCE
Disconnect the power to the unit.
1.
2.
Remove the intake grill by removing the locking screw on
each end of the unit. Lift the intake grill up and then towards
you. See Figure 10.
3.
Open the bottom access panel by removing the Phillips
head screws on the bottom of the unit. Vacuum and scrape
(if necessary) to remove the build-up of dirt and debris.
The motor(s) are permanently lubricated and require no
additional lubrication. Re-install the cover and intake grill.
4.
Switch the power on after cleaning.
CAUTION: STAND CLEAR OF THE UNIT OR WEAR SAFETY
GOGGLES AS LOOSE DEBRIS MAY BE PRESENT AND MAY
EXIT THE NOZZLE.
CAUTION: ELECTRIC SHOCK HAZARD Disconnect power
whenever servicing unit. More than one disconnect may
be required to de-energize unit.
IX. SERVICE
Any service performed on the ARCHITECTURAL HIGH
PERFORMANCE 10 Series air curtain MUST be done by qualified
personnel. Berner air curtains require very little servicing.
All parts are easily accessible for periodic inspection and
maintenance. Units should be cleaned at least twice a year.
Your particular application (the amount of dirt and dust in the
air) and location of the unit(s) will determine how often your
unit(s) will need to be cleaned and serviced. All motors have
permanently lubricated, sealed, sleeve bearings and require no
maintenance.
Grill Locking Screws
-8-
Intake Grill
Figure 10