Table of Contents
Advertisement
III. WALL MOUNTING
A.
PREPARATION
1.
Position and center the mounting plate over
the door opening. The mounting plate must be
positioned with the 45° lip and the rubber vibration
gasket on top.
2.
Mark and drill holes on the mounting plate where
the wall will provide sufficient support for the
Air Curtain. A minimum of four holes close to
the corners is recommended. See Figure 4. The
mounting hardware (supplied by others) must be
capable of supporting a minimum of three times
the net weight of the Air Curtain. See Weight Chart,
Table 1.
3.
Drill the four holes as marked on the wall and attach
the mounting plate with anchors (if used) and the
four mounting screws (provided by others).
ATTACHING THE AIR CURTAIN TO THE MOUNTING
B.
PLATE
1.
Raise the unit over the door (air discharge nozzle
facing down) and on to the mounting plate. First, tilt
the unit upward matching the top recessed edge of
the unit to the top 45° angled lip on the mounting
plate. See Figure 5.
2.
Lower the unit into place, allowing it to rest on the
lower lip of the mounting plate.
3.
After the unit is securely attached to the mounting
plate, re-install the two (2) locking screws at the
bottom corners. See Figure 5.
4.
Proceed to Section V - ELECTRICAL CONNECTIONS
IV. SUSPENDED MOUNTING
A.
When the air curtain is top mounted, the wall
mounting plate is designed to store on the back of the air
curtain for future use. See Figure 5.
B.
For top mounting using suspension rods, four (4) factory
installed 5/16" threaded inserts are located on the top of
the unit. See Figure 6.
C.
Install 5/16" threaded rods, or other suitable hardware
at a location sufficient support the Air Curtain. The
mounting hardware (supplied by others) must be capable
of supporting a minimum of three times the net weight
of the Air Curtain. See Weight Chart, Table 1.
D.
Attach 5/16" threaded rods, or other suitable hardware to
the top mounted threaded inserts.
E.
Proceed to Section V – ELECTRICAL CONNECTIONS
Recommended Mounting
Plate Holes
Doorway Opening
45˚ Lip and Rubber
Discharge
Nozzle
2 Locking Screws
(One In Each Corner)
Suspension Rods
5/16" Recessed Insert
-5-
45º Lip and Rubber
Vibration Gasket
1"
Figure 4
Vibration Gasket
Mounting
Plate
Figure 5
Side View
Figure 6
Hide quick links:
Advertisement
Table of Contents
