Table of Contents
Advertisement
TROUBLESHOOTING
Label Placement Problems
CONDITION
Labels not placed in same place on media.
When applied label is not aligned on media.
Two or three labels applied evenly spaced.
Several labels applied one after another on
the media.
SOLUTION
Label placement should be within +/- 1/8"
1.
Check pitch setting for label. It should
be slightly more than label size plus
space between labels.
2.
Check amount of head pressure.
Too little can cause media to slip when
it is being fed.
1.
Media may not be traveling along
Fixed Side Guide. Adjust angle of
Guide Rollers by turning Knob on
Skew Guide.
2.
Check pressure between Head and
Transport. Too much pressure will
cause media to flex as it is transported.
Programming issue. When applying labels
make sure that you select one label rather
than two or three.
Tab (Label) Sensor adjustment improper.
Check Tab Voltage and Backing Voltage
adjustments. (Page 21)
42
Advertisement
Table of Contents
