Table of Contents
Advertisement
ASSEMBLY AND INSTALLATION
Feeder Base Guide:
1. Remove protective tape from Feeder Base
Guide [A]. NOTE: DO NOT remove the
Teflon tape strip from the bottom of the
channel on the Guide [B].
Remove two rubber feet [C] from the closed
end of the Feeder Base.
2. Align the Feeder Guide with holes in the
Feeder Base.
3. Attach Feeder Guide using rubber feet
removed in Step 1.
Install Feeder Base Guide on Tabber Feeder Guide:
1. Fit channel on Feeder Base Guide over the flange
on the Tabber Feeder Guide [A].
NOTE: Make sure the Feeder Base and
Tabber are at the same level.
2. Place the Feeder on the Feeder Base. Insert the
Feeder's rubber feet into the recesses on the
surface of the Feeder Base [B].
3. Slide the Feeder and Base along the interlocking
Feeder Guides to align the Feeder and Tabber for
different media widths [C].
8
Advertisement
Table of Contents
