Table of Contents
Advertisement
Tab Placement Problems (continued)
CONDITION
Less of the tab is on the top of the media
than on the bottom.
Tab is not flush with edge of media.
When double tabbing one tab is not placed
properly on edge of media.
Two or three tabs applied next to each other.
More than three tabs applied on each piece.
SOLUTION
Adjust Fine Adjustment Knob (Page 12)
counterclockwise to place more of tab to
top side of media.
Media is not being fed flush with Fixed
Side Guide. (Should be no more than 1/8"
to 1/32" space between media and Fixed
Side Guide when media enters Tabber).
1.
Media may not be traveling along
Fixed Side Guide. Adjust angle of
Guide Rollers by turning Knob on
Skew Guide.
2.
Check pressure between Head and
Transport. Too much pressure causes
media to flex as it is transported.
3.
Too little pressure can cause media to
skew as tab is being applied.
Programming issue. When programming
multiple tabs, Together was selected
instead of Separate. Reprogram job.
Tab Sensor adjustment improper.
Check Tab Voltage and Backing Voltage
adjustments. (Page 21)
41
TROUBLESHOOTING
Advertisement
Table of Contents
