Cutterblade - Hayter HARRIER 56 Owner's Handbook Manual

1.30

CUTTERBLADE

WARNING - PREVENT ACCIDENTS : Never work on the cutterblade unless
the spark plug lead has been removed. The cutterblade has sharp edges. ALWAYS
wear strong gloves to protect your hands when working on the cutterblade. DO
NOT rotate tools towards the cutting edges to avoid the risk of injury should the
tool slip. ALWAYS use genuine Hayter replacement parts.
The condition of the cutterblade and its mounting arrangement should be checked
regularly for signs of wear or damage. Ensure that the cutterblade is not bent or
cracked.
A damaged cutterblade that is out of balance will vibrate excessively and may
break. DO NOT use an unbalanced cutterblade.
Regularly check that the screws securing the cutterblade are tightened to the spec-
ified torque of 40Nm.
Replace the cutterblade and screws every 2 years or sooner if excessively worn
or damaged.
How to remove the cutterblade: Drain the fuel by operating
the engine until the fuel tank is empty and the engine stops.
Remove the spark plug lead and allow the engine to cool. Turn
the mower on its left hand side and ensure that the air cleaner
side of the engine is uppermost.
CAUTION- PREVENT INJURY : It is wise to seek assis-
tance when turning the mower onto its side.
Firmly grip the end of the cutterblade with the gloved hand and
remove the two fixing screws (1) securing the cutterblade (2).
How to assemble the cutterblade: Assemble the cutterblade
(2) with the turned up edges facing towards the engine. Secure
the cutterblade using two new fixing screws (HayterPart No:
09732) and tighten to 40 Nm torque.
WARNING - PREVENT ACCIDENTS: Never reuse the fixing screws. Always
use new cutterblade fixing screws when refitting or replacing the cutterblade.
MAINTENANCE
1.30
1
2 CS209
1. Fixing Screw
2. Cutterblade.
343046BD310100