Driving Instructions 10; Driving Instructions Pll, Ple, Psl, Psd, Ps, Psh, Plp - UniCarriers PLL Series Instruction Handbook Manual

Driving instructions PLL, PLE, PSL, PSD,
PS, PSH, PLP
Starting the truck
1) Connect the battery plug and check that the emergency
stop function is disengaged.
2) If the truck is equipped with an electric lock, turn the key.
The display briefly shows a start image.
3) A request to state the operator identification will be
displayed. You will be asked to enter an Operator ID. Note
that there must be as many digits as question marks.
Operator ID:
?
4) Enter your PIN code.
Operator code
????
5) When the valid Operator ID and PIN code have been
entered, the truck will be ready to drive.
DRIVING INSTRUCTIONS 10
NOTE!
If a lever is activated when the truck is started,
you will see a message on the display asking
you to reposition the lever to neutral position.
Then the truck may be operated. This means
that sudden movements are avoided when
starting.
Driving instructions
1) Start the truck in accordance with Starting the truck page
33. Release the parking brake by moving the tiller arm
backwards-downwards (but not to the bottom position).
2) The truck begins to move when the tiller arm speed control
is pushed forwards/backwards. The further the speed
control is moved the faster the truck will move.
3) There are several ways to brake the truck:
• Brake the truck by reversing, i.e. changing the
direction of travel.
NOTE!
The further the speed control is moved the
greater the braking capacity.
33