GSE EC User Manual page 34

CZ G-Systems Engineering
Now you can set the speed which should correspond to 1% of the
minimum speed. Push the knob to change the displayed value with rotating
the knob. Save the new value with pushing the knob. Turn clockwise the knob
and go to the next setting. Repeat for all coming settings.
Choose between Automatically, ON OFF (default is Auto.)
Choose between 0-10V or PWM pulse wide modulation. (default is 0-
10V).
Choose if the intake fan should stop running if the temperature and
humidity value is below them settings. (default is OFF)
Chose if you want to reset the controller to them factory settings. Push
the knob and the value will start blinking. Then press again and hold for 4
seconds to reset.
Leave the sub setting menu
Turn clockwise the knob to the "end" confirm the setting pushing the
knob. The EC fan controller initializes with the new settings.
P-2 Back-light settings
P-3 Output signal
P-4 Intake fan settings
P-5 Reset to factory settings
EN
31