Advertisement
Available languages
Available languages
Activate you warranty online http://g-systems.eu/warranty/
An incorrect connection or short circuit will damage sensitive processor parts
of the appliance! Connect it to the EC fan controller 18. Sensor connection.
Connect the 20 + 21 exhaust and intake air fan with the two supplied 4m
extension cables. Connect the 19. Power supply with a conventional
household outlet.
min.
max .
You find these three buttons on the fan controller UP, DOWN and
SAVE/SET. With the buttons UP and DOWN you can navigate through the
single settings.
The power LED blinks and
the fan starts to initialize This
takes a few seconds. As first you
will see a screen with all the LCD
segments and back-light working.
Next it starts initializing the
sensor and in case this screen
stays at this stage, there is a fault
w i t h t h e s e n s o r o r t h e
communication it self. Check the
connection from the sensor to the
device. If it is still faulty return the
device to be repaired.
Otherwise you will find in a
few seconds the the measured
value, fan speed bar and
day/night stage.
set
save
If you press DOWN once you
will find the temperature day
setting. This setting you will see
for about 10sec. and then it goes
automatically back to the home
position and the back-light stops
working.
EN
EN
27
Advertisement
