Ryobi TSS702 Operator's Manual page 22

LED LIGHTING SYSTEM
See Figure 26.
WARNING:
Do not stare into the light beam (not even from a distance).
Staring into the light beam may result in serious injury or
vision loss.
The LED lighting system casts the shadow of the blade onto
the workpiece. This results in greater accuracy of cuts and
requires no adjustments.
To use this feature, turn the LED switch on.
Bring the saw arm down so the blade is approximately 1/4 in.
from the workpiece. The shadow of the blade will be projected
onto the workpiece, indicating where the blade teeth will make
contact as the cut is made.
TO MAKE NON-SLIDING CUTS
WARNING:
Securely tighten the slide lock knob when making any non-
sliding cuts. Failure to tighten the knob could result in the
saw head moving during the cutting operation.
TO MITER CUT/CROSS CUT
See Figures 27 - 28.
A cross cut is made by cutting across the grain of the workpiece.
A straight cross cut is made with the miter table set at the 0°
position. Miter cross cuts are made with the miter table set at
some angle other than 0°.
NOTE: It may be necessary to adjust the partial sliding miter
fence to ensure proper clearance prior to making the cut.
 Slide the saw head to its most rearward position and tighten
the slide lock knob securely.
 Raise saw arm to its full height.
 Loosen the miter lock handle approximately one-half turn
and squeeze the detent release lever.
 Rotate the control arm until the pointer aligns with the desired
angle on the miter scale.
 Release the detent release lever, then tighten the miter lock
knob to secure the miter table.
NOTE: You can quickly locate 0°, 15°, 22-1/2°, 31.6°, and
45° left or right by releasing the detent release lever as you
rotate the control arm. The control arm will seat itself in one
of the positive stop notches, located in the miter table base.
 Place the workpiece flat on the miter table with one edge
securely against the fence. If the board is warped, place
the convex side against the fence. If the concave edge of a
board is placed against the fence, the board could collapse
on the blade at the end of the cut, jamming the blade. See
Figures 41 - 42.
 When cutting long pieces of lumber or molding, support the
opposite end of the stock with a roller stand or with a work
surface level with the saw table. See Figure 32.
 Turn the LED switch on.
OPERATION
WORK
CLAMP
22 − English
LED
SWITCH
SHADOW OF BLADE
TEETH PROJECTED ONTO
WORKPIECE
CROSS CUT
Fig. 26
Fig. 27