HOW TO CHANGE THE JACK PANEL POSITION
The I/O jack panel of the PMC-25 can be placed either on the top or back side of the unit. Please refer to
following Fig.
Initially, the I/O panel is placed on the top-side. In case of changing the jack panel position to TYPE
please use following instructions.
Remove 5 pieces of silver screw, which secure the
●
PANEL ①.
Remove 5 pieces of silver screw, which secure the
●
PANEL ②.
CAUTION
Please ensure use of the proper screwdriver
(3mm Phillips type).
screwdriver upright and turn slowly. Do not use
excessive force, or it may damage the screw
head.
Install the PANEL ① to the back side and secure it
●
with 5 silver screws.
Install the PANEL② to the top side and secure it with
●
5 silver screws.
Please hold the
9
,
B