F U N C T I O N S; Program Input Section - Vestax PMC-25 Owner's Manual

F U N C T I O N S

PROGRAM SECTION
MIC SECTION
PROGRAM SECTION
1
3
○
INPUT SELECT (Input Select Switch)
1
Used to select input to be sent to each PGM channel.
○ TRIM (Trim Control Volume)
2
Adjusts the Input level of each channel. For proper
adjustment, please set the INPUT FADER to
Maximum position then adjust TRIM so that the
INPUT LEVEL METER shows around 0 dB at
nominal level.
○ PEAK
3
Turns on when the signal of HI, MID, LOW range
hits the peak.
○ HI (Isolator HI)
4
Cuts and boosts the high frequency range. The level
is flat when this knob is set at 12 o'clock. High
frequency range is boosted up to +4dB when this
knob is rotated clockwise. When the knob is rotated
counter-clockwise, high frequency range is cut off
up to infinity level. For example, it can be used to
emphasise or cut off the cymbals or high hats.
MASTER SECTION
9 8
6 5
○
MID (Isolator MID)
5
Cuts and boosts the mid frequency range. The level
is flat when this knob is set at 12 o'clock. Mid
frequency range is boosted up to +4dB when this
knob is rotated clockwise. When the knob is rotated
counter-clockwise, mid frequency range is cut off up
to infinity level. For example, it can be used to
emphasise or cut off the vocals or guitars.
○
LOW (Isolator LOW)
6
Cuts and boosts the low frequency range. The level
is flat when this knob is set at 12 o'clock. Low
frequency range is boosted up to +4dB when this
knob is rotated clockwise. When the knob is rotated
counter-clockwise, low frequency range is cut off up
to infinity level. For example, it can be used to
emphasise or cut off the bass.
4
2
7
10
4
MONITOR SECTION