Standard Memory Operation; Memory Storage; Memory Channel Recall - Yaesu FT-2000 Operating Manual

M O
EMORY
The Standard Memory of the FT-2000 allows storage and recall of up to 99 memories, each storing frequency, mode, and
a wide variety of status information detailed previously. Memories may be grouped into as many as six Memory Groups,
and additionally you get nine pairs of band-limit (PMS) memories along with five QMB (Quick Memory Bank) memories.

Memory Storage

1. Set the Main band (VFO-A) up with all frequency,
mode, and status the way you want to have it stored.
2. Press the [ A M ] button momentarily (the current chan-
nel number will start blinking in the multi-panel win-
dow); the contents of the current memory channel will
be shown on the Sub band (VFO-B) display field.
3. Rotate the [ SUB VFO-B ] knob to select the memory
channel onto which you wish to store the data. If you
have selected a channel on which data is already stored,
that frequency will appear on the Sub band's (VFO-B)
frequency display field.
4. Press and hold in the [ A M ] button for two seconds
to store the frequency and other data into the selected
memory channel. A double beep will confirm that you
have held the [ A M ] button in long enough.

Memory Channel Recall

1. Press the [ V/M ] button, if necessary, to enter the
Memory mode. A memory channel number will ap-
pear in the multi-panel window.
2. Press the [ M CH ] button. The Red LED inside the but-
ton will light up, indicating that you are ready to recall
a memory channel.
A :
If the Red LED imbedded in the [ M CH ] button does
not light up, check to be sure that the orange lamp to
the right of the [ SUB VFO-B ] knob is not illuminated.
If it is, press the [ A/B ] switch to make it go out, then
press the [ M CH ] button again.
3. After pressing the [ M CH ] button, you may rotate the
[ M CH ] knob to select the desired memory channel.
A :
To work within a particular Memory Group, press the
[ GRP ] button (the imbedded LED will glow Red), then
rotate the [ SUB VFO-B ] knob to select the desired
Memory Group. Now press the [ M CH ] button (the im-
bedded LED will glow Red); you may now choose the
memory channel within the selected Memory Group.
Page 96
PERATION
S M
TANDARD EMORY
O
PERATION
FT-2000 O
[ A M ] Button
[ SUB VFO-B ] Knob
[ V/M ] Button [ A/B ] Button
[ SUB VFO-B ] Knob
[ GRP ] Button
[ M CH ] Button
M