Yaesu FT-2000 Operating Manual page 33

RX ANT OUT Jack
This BNC jack provides output of the receiver signal
lines from the Antenna jacks which are connected to
"RX" side of the transceiver's main T/R switching cir-
cuitry.
RX ANT IN Jack
This type-M jack is for a separate receive-only antenna.
An antenna connected here can be used when the [ RX ]
antenna button on the front panel is pressed.
If you want to use some special kind of external
bandpass filter or preamplifier, you may connect it
between the RX ANT OUT and RX ANT IN jacks.
ANT 1/2 Jacks
Connect your main antenna(s) here, using a type-M
(PL-259) plug and coaxial feedline for each. These an-
tenna ports are always used for transmission, and also
are used for reception unless a separate receive an-
tenna is also used for the receiver. The internal antenna
tuner affects only the antenna(s) connected here, and
only during transmission.
ANTENNA ( 1/2 ) SWITCH
TX/RX RELAY
ANT "1"
ANT "2"
RX ANT "OUT"
RX ANT "IN"
FT-2000 O
Transmitter Section
ANTENNA ( RX ) SWITCH
Receiver Section
M
R
EAR
DC OUT
This is DC power output lead from the internal AC
power supply. Connect this pigtail to the DC IN Jack
of the transceiver.
~AC IN Jack
Connect the supplied 3-wire AC line cord to this socket
after ensuring that your AC mains voltage matches that
on the label. See the Installation section for instruc-
tions on how to change the internal switching power
supply AC mains voltage, if necessary.
FUSE
This holder requires a 10-A fuse. Always use the 10
Amp fuse, whether operating on 100 - 120 VAC or
200 - 240 VAC.
Main Power Switch
This is main power On ( I ) /Off ( O ) switch of the FT-
2000. Always turn this switch on before turning on the
front panel's [ POWER ] button.
If this switch is not turned On, the front panel
[ POWER ] switch will not function.
GND
Use this terminal to connect the transceiver to a good
earth ground, for safety and optimum performance. Use
a large diameter, short braided cable for making ground
connections, and please refer to page 9 for other notes
about proper grounding.
µ-TUNE Jacks
These jacks are used for signal input/output of the op-
tional RF µTuning Kit.
P
ANEL
Page 31