Connection/Start; Reset Motor Protection; Maintenance - Nederman Side channel fan Series Instruction Manual

NOTE! When the filter is clogged or the pre-separator is full, suction power is reduced.
Clean the filter and empty the pre-separator. See Section 7 Maintenance.
NOTE! For best results, adjust the gulper head depending on the type and weight of
material to be vacuumed, see Figure 9.
6.2

Connection/start

NOTE! During start, the vacuum cleaner may move in a sideways direction, so be sure to
always hold onto the vacuum cleaner when starting.
The suction hose is connected to the fan. The starting handle makes Y/D start
possible in both rotational directions. When starting, the lid for filter cleaning
should be slightly opened, and the motor's direction of rotation compared
with the arrow. When the motor rotates in the correct direction, allow the
motor to reach full revs before switching to D position.
If the motor rotates in the wrong direction, turn the start button back to zero.
Allow the motor to stop and then start the fan again turning the start button in
the other direction.
6.3

Reset motor protection

CAUTION! Risk of equipment damage.
Check why motor protection was activated and correct the problem. See
section 9 Troubleshooting.
If motor protection is activated, the fan is turned off. To restart the fan, do the
following, see also Figure 3:
1. Turn the Start switch (a) to the 0 position.
2. Press in the button (b).
3. Turn the Start switch back on to restart the fan.
7

Maintenance

WARNING! Risk of personal injury.
• Work with electric equipment is to be carried out by a qualified electrician.
• Always disable control system before disconnecting power to vacuum
cleaner.
• Completely disconnect the vacuum cleaner from all power sources before
any type of service or transportation.
• Empty dust into a container or dust bag, see Figure 11.
• Do not place vacuum cleaner on an uneven surface.
• Always use proper protective equipment where there is a risk for exposure
to dust, see Figure 11.
• Always use proper lifting equipment and protective gear.
CAUTION! Risk of equipment damage.
• Replace all damaged components with original spare parts.
• Turn off vacuum cleaner if dust escapes from it.
• Store vacuum cleaner in standing position.
S - Vacuum Cleaners EN
19