Protective Guardrail - HOLLAND LIFT HL-140 E12 Instruction Manual

HL-140 E12 / HL-160 E12 / HL-190 E12 / HL-220 E12
N-120EL12 / N-140EL12 / N-165EL12 / N-195EL12
Rev. F
Component
Batteries
Limit switches for height
stops
Tilt safety device
Wheels
PLC operation
Electric motors

Protective guardrail

7.1.1
The protective guardrail on the bottom carriage prevents body parts from becoming trapped by the
moving scissor arms.
Note!
If the guardrail is removed during maintenance work, it must be reinstalled correctly once the
maintenance work has been completed.
It is not permitted to use the scissor lift when the protective guardrail is not fitted or does not work as
intended.
The protective guardrail must be removed before lubrication.
Make sure the guardrail is properly installed before the scissor lift is used again.
Page 43
Action
Check fluid levels. Top up if necessary.
Recharge the battery if the scissor lift has not been
used for more than 2 weeks.
Check operation and adjustment.
Make sure it works correctly.
Tighten the wheel bolts according to the tightening
torque chart.
Raise the wheels off the ground if the scissor lift is not
going to be used for a long period of time.
Replace batteries. Only do so while the PLC is
connected to a power supply, so the program in the
memory will not be lost.
Check the carbon brushes for wear. Replace if
necessary, and clean the collector.
Frequency
Every week
Every two weeks
when not in use
Every week
Once every
3 months
Once every
3 months
-
Every 4 years
Once every
3 months
8/2/18