2.7.10 Tilt Indicators; 2.7.11 Other Safety Provisions - HOLLAND LIFT HL-140 E12 Instruction Manual

HL-140 E12 / HL-160 E12 / HL-190 E12 / HL-220 E12
N-120EL12 / N-140EL12 / N-165EL12 / N-195EL12
Rev. F
Comments
Only for scissor lifts with the 'Drive at full height' option:
It is possible to reactivate the driving and steering functions when the platform is at a height of

more than 8 metres by placing the key switch on the electronics box in position '1'.

2.7.10 Tilt indicators

If the scissor lift exceeds the specified maximum tilt when the platform is at a height of more

than 3 metres, a warning signal will sound and all the movement functions will be deactivated,
with the exception of the descent function and the (manual) retraction of the platform.
1.
Extra indicator for 1 degree of tilt in the longitudinal or transverse direction (with the 'drive at
full height' option).
2.
Standard tilt indicator.

2.7.11 Other safety provisions

Tilt protection
The tilt protection prevents the machine from tipping over while the lift is being driven if a wheel runs
over a hole. The tilt protection extends when the platform is above 3 m.
Overload protection
The overload safety device informs the operator when the platform is overloaded. If the permitted
load is exceeded (between 100-120%), all of the scissor lift's movement functions will be
deactivated. An acoustic signal will also sound for 5 seconds every minute and the overload light
with be lit. When the overload safety device is activated the excess load must be removed, after
which the scissor lift's movement functions will become active again. It is recommended that
persons on the platform take communication equipment with them for use in the event of a
malfunction.
Page 23
Tilt indicators
8/2/18