Terms Of Delivery And Warranty; Terms Of Delivery; Warranty; Intended Use And Modifications - HOLLAND LIFT HL-140 E12 Instruction Manual

HL-140 E12 / HL-160 E12 / HL-190 E12 / HL-220 E12
N-120EL12 / N-140EL12 / N-165EL12 / N-195EL12
Rev. F
9.
the maximum horizontal force (N)
10.
the maximum angle of inclination (°)
11.
the maximum wind speed (m/s)
12.
the maximum tilt (°)
13.
the maximum height (m)
14.
the maximum height when mobile
15.
the minimum permissible temperature (°C)
16.
the maximum operating pressure (bar)

Terms of delivery and warranty

1.7

Terms of delivery

1.7.1
All sales agreements with HOLLAND LIFT INTERNATIONAL B.V. are subject to the Metaalunie
terms and conditions.

Warranty

1.7.2
See the terms of delivery for the length of the warranty.

Intended use and modifications

1.8

Intended use

1.8.1
The scissor lift is only intended to be used to allow people to work at a height. The maximum load of
the platform (see type plate) must not be exceeded under any circumstances. Any other use is
contrary to the scissor lift's intended use. Only use the scissor lift in enclosed spaces with an
ambient temperature of between -15 °C and +40 °C.

Modifications

1.8.2
Modifications may only be made to the scissor lift after written permission has been obtained from
the management of HOLLAND LIFT INTERNATIONAL B.V.
The information contained in this instruction manual is based on the information regarding
constructions, material properties and work methods that was known to us at the time of publication.
We therefore reserve the right to make construction modifications. For this reason, HOLLAND LIFT
INTERNATIONAL B.V. also reserves the right to make alterations to the content of the instruction
manual without any prior notice.
Components may only be replaced by components provided by HOLLAND LIFT INTERNATIONAL
B.V. or components which can be considered to be of a comparable quality. HOLLAND LIFT
INTERNATIONAL B.V. reserves the right to decide whether these components are of a comparable
quality. The manufacturer can only be held liable if a written declaration stating that the components
are of comparable quality has been obtained from the manufacturer.
8/2/18
Page 8