Safety Instructions During Maintenance; Safety Instructions When Working On The Electrical System; Safety Instructions When Working On The Hydraulic System - HOLLAND LIFT HL-140 E12 Instruction Manual

HL-140 E12 / HL-160 E12 / HL-190 E12 / HL-220 E12
N-120EL12 / N-140EL12 / N-165EL12 / N-195EL12
Rev. F
It is strictly forbidden:

• to operate the scissor lift from the ground using the control box (except for transport
reasons or when carrying out maintenance work on the scissor lift)
• to use the scissor lift to carry out work on or near high-voltage electrical lines
• to use the scissor lift to work in an area where there is a risk of explosion

Safety instructions during maintenance

2.2.3
Always wear the required safety equipment (e.g. safety goggles, hearing protection, helmet)

when carrying out maintenance work on the scissor lift.
Prevent the scissor lift from being able to roll away. For example, place chocks against the

wheels.
Prevent the risk of crushing in the scissor mechanism. Make sure the safety prop has been

fitted before working on parts such as the scissor mechanism (e.g. lubricating the scissor
mechanism).
If the scissor lift is switched off during maintenance work and must remain off, take measures

to prevent the scissor lift from being switched on unexpectedly or unintentionally. Make sure
others cannot undo the measures that have been taken.
Before cleaning the scissor lift with steam, water or other liquids, protect all components that

must not be exposed to liquids. Remove the protection after cleaning the scissor lift.
Make sure oil, grease and other substances that are harmful to the environment are disposed

of in a safe and environmentally-friendly manner.

Safety instructions when working on the electrical system

2.2.4
Turn off the scissor lift before working on the electrical system.


Safety instructions when working on the hydraulic system

2.2.5
Make sure the correct fire extinguisher is available. Leaking oil can be hot and may therefore

cause a fire.
Lower the platform as far as possible before carrying out work on the hydraulic system.

Release the pressure before working on the hydraulic system.

Do not touch the hydraulic systems lines. Leaking, hot oil can cause burns or penetrate the

skin. If you come into contact with the oil, immediately contact a doctor who has experience
with this type of injury.
8/2/18
Page 12