HOLLAND LIFT HL-140 E12 Instruction Manual page 38

HL-140 E12 / HL-160 E12 / HL-190 E12 / HL-220 E12
N-120EL12 / N-140EL12 / N-165EL12 / N-195EL12
Rev. F
2.
LED bar graph
3.
Hour counter
4.
20%
The LED bar graph (2) indicates the batteries' state of charge. All LEDs on means: battery fully
charged. The fewer LEDs that are lit, the less charge remaining in the battery. When all the LEDs on
the bar graph are off, the 20% LED (4) lights. The 'battery voltage too low' indicator lamp on the
control box then also lights. An acoustic signal also sounds. The raise function is now no longer
available. You now have 10 minutes remaining to descend and drive to a charging point if
necessary. After that time, none of the scissor lift's functions will be operable any more. Use of the
emergency stop function during this 10-minute period will also deactivate all of the scissor lift's
functions. In that case, a new 10-minute cycle can be started by briefly pressing the descend button
on the left side of the electrical box. This procedure resets the 10-minute cycle.
Comment
If the emergency stop function is used during the 10-minute cycle, all functions are disabled
from that moment.
The 10-minute cycle can be restarted by briefly pressing the descend button on the left side of
the electrical box. This action re-activates the 10-minute cycle.
8/2/18
Battery state-of-charge meter
Page 38