Table of Contents
Advertisement
The EB-1 Electrical junction box has been fitted stand-
ard on this model to allow for the easy connection of an
optional fan kit.
To connect the EB-1 box to the house electrical supply
follow the steps below.
1. Unscrew the retaining screw from the EB-1 base
plate and remove the EB-1 assembly from the
appliance. (Fig. 9)
2. Remove the front cover of the EB-1 box.
3. Remove the plug socket assembly from the EB-1
box.
4. Feed the supply line in through the EB-1 opening in
the side of the appliance and then through the back
of the EB-1 assembly. (Fig. 9)
5. Connect the black wire of the power supply line to
the brass screw (polarized) of the socket assembly.
6. Connect the white wire of the power line to the
chrome screw of the socket assembly.
7. Connect the ground wire of the supply line to the
green screw of the socket assembly.
8. Refit the socket assembly back into the electrical
box and replace the cover plate. Secure the cable
with the clamp on the outside of the EB-1 base
plate and refit the EB-1 assembly to the unit with the
screw removed in step 1.
CIRCUIT BOARD
Fig. 10 SIT822 Valve with Synetek electronic control wiring diagram.
10009383
Fig. 9 EB-1 receptacle.
This appliance may be fitted with a Synetek ignition
module.
Installation of the remote on/off starter switch or
wall thermostat on electronic ignition units.
1. Thread the wiring through the holes on the side
panels of the appliance. Take care not to cut the wire
or insulation on metal edges. Route the wire to a
conveniently located receptacle box.
2. Attach the wire to the ON/OFF switch and install the
switch into the receptacle box.
BLACK
L1
WHITE
L2
GREEN
PURPLE
BLUE
RED
WHITE
FP1571
XDV Direct Vent Gas Fireplace
INSIDE
OUTSIDE
Electronic Gas Control Valve
POWER CORD
PILOT SENSING
PILOT IGNITER
YELLOW
P
M
O
O
VALVE
ORANGE
ON/OFF SWITCH
OR
WALL THERMOSTAT
Electrical Box
FP580
FP580
INSTA VENT FREE
EB1 JUNCTION BOX
11/18/97
FP1571
9
Hide quick links:
Advertisement
Table of Contents
