Vermont Castings 33XDV Installation Instructions And Homeowner's Manual page 26

XDV Direct Vent Gas Fireplace
4. Place the log front (A50). Place the two
underside holes of the log over the two pin
studs of the bracket located at the front of the
burner housing. (Fig. 52)
5. Place the log top right (A52). Place the bot-
tom round hole onto the knob at the right side
of the rear log. The cross section of the log
will rest on top of the center right log. (Fig. 53)
6. Position the log cross over center (A53) by
locating the bottom rectangular slot of this
log onto the knob at the center of the front
log. The other end of the log, with the bottom
round hole, will be on the knob located on the
top center of the rear log. (Fig. 53)
Figure 53
Log Left Top
(A54)
Log Rear
(A49)
Log Front (A50)
Lava Rock
1. Place the log rear (B152). Place the two
underside holes of the log over the two
pins studs of the rear log bracket. (Fig. 54)
26
LG956
Log Cross Over
Center (A53)
Ember Material
36XDV
�����
����� ����
����
Figure 52
Log Top
Right (A52)
�����
����� ����� ���
����
Log Center
Right (A51)
LG958
Lava Rock
Figure 54
�����
���� ���
����
Log Front (A50)
7. Place the log left top (A54). Place
the bottom rectangular slot of this
log onto the knob at the left side
of the front log. (Fig. 53)
8. Place large lava rock onto the
two sides of the burner tray as
shown in Figure 53.
Do not place any of the
lava rock material on the
burner housing assem-
bly.
Log Rear
(B152)
Ember Material
LG948
10009383