GE IM-4 Owner's Manual And Installation Instructions page 46

ICEMAKER INSTALLATION INSTRUCTIONS P
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator from
its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
PREPARE FOR INSTALLATION
1
• Remove and discard the large white plug from the
rear freezer wall. Pull out the gray insulation plug
and remove any debris.
• Remove the two small white plug buttons on the side
wall. Install two Phillips head screws (14) in the holes
that the plug buttons were in, but do not screw them
all the way in. The screw heads should extend about
1/2" (13 mm) from the side wall of the freezer.
• Remove the outlet cover with a flat-blade
screwdriver.
14
Installation Instructions
C
Unplug the
Sharp knife
Pliers
F G H J K L M
2 INSTALL FILL TUBE
• Cut the fill tube (16) to the
length (refer to the
on page 62) with a sharp knife
or a single-edge razor blade.
• Slide the fill tube (16) onto the
water tube inlet (15).
• Cut the fill tube extension (10) to the
(refer to the template on page 63) with a sharp
knife or single-edge razor blade.
• Slide the fill tube extension (10) completely over
the fill tube (16) on the water tube inlet (15).
• Go to the back of the refrigerator. In the upper
right hand corner, remove the label covering the
hole. Pull out the insulation plug and any debris.
• On the tube side of the
water tube inlet (15) there
is an adhesive backing.
Remove the adhesive
backing and slide the tube
into the hole near the top
at the back of the refrigerator. Firmly press on the
inlet to secure it to the refrigerator.
3
SET POWER SWITCH TO OFF
Set the icemaker power switch to OFF. Leave the
power switch in the OFF position until the refrigerator
is connected to the water supply to prevent
premature operation.
Power
Switch
46
or R
N P Q
P
template
P
15
16
length
P
Hole for
wire tie