GE IM-4 Owner's Manual And Installation Instructions page 30

ICEMAKER INSTALLATION INSTRUCTIONS K
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
PREPARE FOR INSTALLATION
1
• Remove and discard the large white plug from the
rear freezer wall. Pull out the gray insulation plug
and remove any debris.
• Remove the upper outlet cover with a flat-blade
screwdriver.
Remove
plug
2 INSTALL FILL TUBE
• Cut the fill tube (16) to the
length (refer to the
template on page 62) with a
sharp knife or a single-edge
razor blade.
• Slide the fill tube (16) onto the water tube inlet (15).
• Go to the back of the refrigerator. On the tube side
of the water tube inlet (15) there is an adhesive
backing. Remove the adhesive backing and slide
the tube into the hole near the top at the back of
the refrigerator. Firmly press on the inlet to secure
it to the refrigerator.
Installation Instructions
Unplug the
Sharp knife
Pliers
K
K
15
C F G H J K L
3 INSTALL MOUNTING BRACKET
• Remove the three small plug buttons on the rear
wall of the freezer and replace them with three
screws (26) supplied with the icemaker kit. Do
not screw them all the way in. The screws should
extend approximately 1/2" (13mm) out from
the freezer wall.
• Install the icemaker
bracket (25) by hanging
it from the three screws
that were just installed.
Tighten the three screws
securely.
4 SET POWER SWITCH TO OFF
Set the icemaker power switch to OFF. Leave the
power switch in the OFF position until the refrigerator
is connected to the water supply to prevent
premature operation.
Power
Switch
5 POWER CORD ADAPTER
There are two power cord adapters included with the
kit; be sure to use the one specified in the Parts List on
page 7. Plug the female end of the power cord adapter
16
(22) onto the male terminals on the icemaker power
cord. When connecting the adapter to the power cord,
make sure the seal is in place between the connectors.
Secure the power cord adapter to the icemaker by
putting it into the hook at the back of the icemaker
and attaching it to the icemaker with a wire tie (24).
Hook
30
or R
M N P Q
22
Wire tie
Hole for
wire tie
Seal
Hook