GE IM-4 Owner's Manual And Installation Instructions page 34

ICEMAKER INSTALLATION INSTRUCTIONS L
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
1/4" Nutdriver or adjustable wrench
REMOVE ICE CUBE TRAY SHELF
1
• Remove the two screws securing the ice cube tray
to the side wall of the freezer. Remove the tray.
• Replace the screws but do not screw them all the
way in. The screw heads should extend about 1/2"
(13 mm) from the side wall of the freezer.
PREPARE FOR INSTALLATION
2
• Remove and discard the large white plug from the
rear freezer wall. Pull out the gray insulation plug
and remove any debris.
• Remove the outlet cover with a flat-blade
screwdriver.
Remove
plug
Installation Instructions
C
Unplug the
Sharp knife
Pliers
F G H J K L M
3 INSTALL FILL TUBE
• Cut the fill tube (16) to the
length (refer to the
on page 62) with a sharp knife
or a single-edge razor blade.
• Slide the fill tube (16) onto the
water tube inlet (15).
• Cut the fill tube extension (10)
to the length (refer to the
L
template on page 63) with a
L
sharp knife or a single-edge
razor blade.
• Slide the fill tube extension (10) completely over
the fill tube on the water tube inlet (15).
• Go to the back of the refrigerator. On the tube side
of the water tube inlet (15) there is an adhesive
backing. Remove the adhesive backing and slide
the tube into the hole near the top at the back of
the refrigerator. Firmly press on the inlet to secure
it to the refrigerator.
4 SET POWER SWITCH TO OFF
Set the icemaker power switch to OFF. Leave the
power switch in the OFF position until the refrigerator
is connected to the water supply to prevent
premature operation.
Power
Switch
34
or R
N P Q
L
template
L
15
16
Hole for
wire tie