GE IM-4 Owner's Manual And Installation Instructions page 18

ICEMAKER INSTALLATION INSTRUCTIONS G
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
INSTALL WATER TUBE INLET
1
If the refrigerator already has a water tube inlet
on the back of the refrigerator, go to Step 2.
• Cut the fill tube (16) to the
to the template on page
G
62),with a sharp knife or a
single-edge razor blade.
• Slide the fill tube (16) onto
the water tube inlet (15).
• Find the small label in the
upper right hand corner on the back of the
refrigerator. Peel off the label.
• On the tube side of the
water tube inlet (15) there
is an adhesive backing.
Remove the adhesive
backing and slide the tube
into the hole near the top
at the back of the refrigerator. Firmly press on
the inlet to secure it.
REMOVE PLUG COVER
2
Remove the electric plug cover from
the left side wall of the freezer by
pulling the cover (A) straight out
while pressing the sides of the cover
to free its tabs from the slots. Discard
the cover.
Installation Instructions
C
Unplug the
Pliers Sharp knife
G length (refer
16
15
F G H J K L M
LOOSEN MOUNTING SCREWS
3
Loosen the two mounting screws (B) but do not
screw them all the way out. If your model does not
have the screws already in the freezer wall, look for
two plug buttons. Remove the plug buttons and
insert the two Phillips head screws (14). The screws
should extend approximately 1/2" (13 mm) out
from the freezer wall.
4 INSTALL FILL TUBE
• Remove and discard the white plug from the
upper left corner of the freezer wall.
• Cut the fill tube extension (10) to the
(refer to the
knife or a single-edge razor blade and slide it onto
the fill tube against the stop.
5
SET POWER SWITCH TO OFF
Set the icemaker power switch to OFF. Leave the
power switch in the OFF position until the refrigerator
is connected to the water supply to prevent
premature operation.
Power
Switch
A
18
or R
N P Q
B
template on page 63) with a sharp
G
10
Remove
plug
length
G
G
Hole for
wire tie