GE IM-4 Owner's Manual And Installation Instructions page 23

6
POWER CORD ADAPTER
There are two power cord adapters included with the
kit; be sure to use the one specified in the Parts List on
page 7. Plug the female end of the power cord adapter
(21) onto the male terminals on the icemaker power
cord. When connecting the adapter to the power
cord, make sure the seal is in place between the
connectors. Secure the power cord adapter to the
icemaker by putting it into the hook at the back
of the icemaker and attaching it to the icemaker
with a wire tie (24).
Hook
INSTALL THE ICEMAKER FILL CUP
7
Install the icemaker fill cup (side-mounted) (18) into
the icemaker as shown.
PLUG IN THE ICEMAKER
8
Place the icemaker on its side as shown. Insert the
icemaker power cord plug (B) into the socket,
making sure the prongs and holes are matched.
Press the plug firmly into the socket.
Installation Instructions
Seal
Wire tie
Hook
18
B
MOUNT ICEMAKER
9
• Lift the icemaker so the fill tube (16) fits in the fill
cup opening (C). Hang the icemaker on the two
mounting screws (A).
Make sure:
• The power cord is still firmly in the socket.
• The fill tube (16) is still in the fill cup opening.
(Check the rear of the refrigerator to make sure the
fill tube has not been pushed out of the back of the
refrigerator.)
• The icemaker mounting screws are located in the
uppermost position of the mounting slots.
THEN TIGHTEN THE ICEMAKER MOUNTING
SCREWS SECURELY.
10
INSTALL THE ICE BUCKET
Put the ice bucket (11) in place under the icemaker.
Make sure the icemaker power switch is set to OFF .
11
ATTACH WARRANTY LABEL
A label (9) is provided with this kit to record the
date of installation for warranty purposes. Apply it
to the back of the refrigerator.
KEEP THIS MANUAL
12
The warranty for the icemaker is printed in this
manual. Keep this manual with your Refrigerator
Owner's Manual.
The icemaker installation inside the freezer is now
complete. Continue to the Water Valve Assembly
section.
23
16
A
C
11