Installation Of Insulated Water Tank; Installation Measure - Gree Versati III Series Owner's Manual

Air-to-water heat pump split
Hide thumbs Also See for Versati III Series:
Table of Contents

Advertisement

SPLIT
TYPE
supply is cut off before disassembling the connection pipe.
If connection pipe is disassembled when the compressor is still operating, air may get into the system. In this
case, system pressure will increase and compressor will be damaged.
During installing the unit, make sure the connection pipe is connected properly before starting the compressor.
,I WKH FRPSUHVVRU LV VWDUWHG EHIRUH ¿QLVKLQJ FRQQHFWLRQ RI FRQQHFWLRQ DQG ZKHQ WKH FXWRII YDOYH LV RSHQHG DLU
may get into the system. In this case, system pressure will increase and compressor will be damaged.
The indoor unit and outdoor unit shall be connected properly with required wire. The wiring terminal shall be
secured properly without affecting by exterior force directly.
,I WKH ZLUH LV QRW FRQQHFWHG SURSHUO\ RU WKH ZLULQJ WHUPLQDO LV QRW VHFXUHG SURSHUO\ ¿UH KD]DUG PD\ EH FDXVHG
7KH ZLUH FDQQRW EH UH¿W RU UHFRQQHFWHG LQ WKH PLGGOH
:KHQ WKH OHQJWK RI FRQQHFWLRQ ZLUH LV QRW VXI¿FLHQW SOHDVH FRQWDFW WKH DSSRLQWHG DIWHUVDOHV VHUYLFH FHQWHU WR
SXUFKDVH D VSHFLDOL]HG ZLUH ZLWK VXI¿FLHQW OHQJWK

18. Installation of Insulated Water Tank

18.1 Installation measure

The insulated water tank should be installed and keep levelly within 5m and vertically within 3m from the indoor
unit. It can be installed in the room.
Standing water tank must be installed vertically with the bottom on the ground, never suspended. Installation
SODFH PXVW EH ¿UP HQRXJK DQG WKH ZDWHU WDQN VKRXOG EH ¿[HG RQ WKH ZDOO ZLWK EROWV WR DYRLG YLEUDWLRQ DV VKRZQ LQ
WKH IROORZLQJ ¿JXUH :HLJKW FDSDFLW\ RI ZDWHU WDQN GXULQJ LQVWDOODWLRQ VKRXOG DOVR EH FRQVLGHUHG
The minimum clearance from the water tank to combustible surface must be 500mm.
7KHUH VKRXOG EH ZDWHU SLSH KRW ZDWHU MRLQW DQG ÀRRU GUDLQ QHDU WKH ZDWHU WDQN LQ IDYRU RI ZDWHU UHSOHQLVKPHQW
hot water supply and drainage of water tank.
Connection of inlet/outlet waterway: Connect the safety check valve attached with the unit (with the arrow on it
SRLQWLQJ DW WKH ZDWHU WDQN ZLWK WKH ZDWHU LQOHW RI ZDWHU WDQN ZLWK 335 SLSH DFFRUGLQJ WR WKH IROORZLQJ ¿JXUH VHDOLQJ
with unsintered tape. The other end of the safety check valve should connect with tap water joint. Connect the hot
water pipe and water outlet of water tank with PPR pipe.
Note
(a) For safe use of water, water outlet/inlet of water tank must connect with a certain length of PPR pipe ,L
•î5 FP 5 LV LQVLGH UDGLXV RI WKH SLSH  0RUHRYHU KHDW SUHVHUYDWLRQ VKRXOG EH FRQGXFWHG DQG PHWDO SLSH
FDQQRW EH XVHG )RU WKH ¿UVW XVH ZDWHU WDQN PXVW EH IXOO RI ZDWHU EHIRUH WKH SRZHU LV RQ
Water Tank
Fix
With
Bolts
Installed on the ground
and never suspended
Safety check valve
Tap water
31
Air-to-water Heat Pump Split Versati

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents