EIP Ebac PP6 Owner's Manual page 2

Carefully remove the PP6 dehumidifier unit from its transit box and visually
check for signs of transit damage. If there is evidence of damage DO NOT
attempt to operate the unit, call your supplier for advice. Do not discard the
packing; it will be useful when transporting the dehumidifier unit in the future.
INTRODUCTION
Dehumidifiers remove moisture from the air that is circulating through the unit.
The resulting reduction of relative humidity helps prevent rust, rot, mould,
mildew and condensation within the room, or other enclosed spaces where
the dehumidifier is used.
A dehumidifier consists of a motor-compressor unit, a refrigerant condenser,
an air circulating fan, a refrigerated surface, a means of collecting and
disposing the condensed moisture and a cabinet to house these components.
The fan draws air through the refrigerated surface and cools it below its dew
point, removing moisture which is collected and led away. The cool air then
passes the hot condenser, where it is reheated. With the addition of other
radiated heat the air is discharged into the room at a higher temperature but
lower relative humidity than when the air entered the unit. Continuous
circulation of the room air through the dehumidifier unit gradually reduces the
relative humidity in the room.
The PP6 dehumidifier is a robust, compact unit designed to control the
•
humidity in the enclosed space in which it is placed.
The unit is thermally protected and will switch off for a period if the
•
maximum operating temperature of 50ºC is exceeded.
The PP6 has been designed for the exacting conditions, which can
•
prevail in the medium to long term storage of mobile shelters and
vehicles. It combines lightness and compactness with high reliability and
strength.
Handles contribute to its portability.
•
The gas which is used inside the hermetically sealed refrigeration circuit
•
is R134a which contains no CFC`s and has therefore a zero ozone
depletion factor. But under no circumstances should this gas be released
into the atmosphere, the unit should be serviced by trained personnel
who will reclaim any of the unwanted gas.
A stowage plate (part no. 1012305) is available to provide secure fixing
•
for the PP6 dehumidifier unit under transport conditions.
UNPACKING
Page 2 of 12
Drawing : - TPC148
Issue : - 4
Date : - 24/11/16