SamplexPower EVO-RC Owner's Manual page 30

SECTION 4 |
4.4.2.3.1 Programming Steps for Parameter "EQUALIZE VOLTAGE"
Enter Key
ð
A N Y O P E R A T I N G
M O D E S C R E E N
4.4.2.4 FLOATING VOLTAGE (Table 4.1, Parameter Setup Screen No.4)
This sets the charging voltage in the Constant Voltage Float Stage.
4.4.2.4.1 Programming Steps for Parameter "FLOATING VOLTAGE"
Enter Key
ð
A N Y O P E R A T I N G
M O D E S C R E E N
4.4.2.5 COMPENSATE (Table 4.1, Parameter Setup Screen No.5)
This parameter sets the temperature compensation for the battery. The operating range of the EVO
is -20°C to 60°C.
This compensation voltage will affect the Absorbtion Voltage/Equalize Voltage/Floating Voltage/Batt Over Volt/Restart
Voltage/Low Volt Alarm/Batt Low Voltage when the Temperature Sensor is installed on the battery (see Fig 2.5 in the
Owner's Manual for Evolution
!
CAUTIONS!
1. Lithium Ion charging does not require temperature compensation. Hence, do not use EVO-BCTS
Temperature Sensor when charging Lithium Ion Batteries.
2. Automatic temperature compensation using EVO-BCTS Temperature Sensor is designed for Lead
Acid Batteries based on programming parameter "COMPENSATE". When charging Nickel-Zinc
(Ni-Zn) batteries, ensure that the value of programming parameter "COMPENSATE" is set based
on approximate linear compensation for the particular Ni-Zn battery.
!
ATTENTIONS!
1. Le chargement au lithium-ion ne nécessite pas de compensation de température. Par
conséquent, n'utilisez pas le capteur de température EVO-BCTS lors du chargement de batteries
au lithium-ion.
2. Compensation automatique de la température à l'aide d'EVO-BCTS Capteur de température
est conçu pour les batteries au plomb basée sur la programmation paramètre "COMPENSATE".
Lorsque la charge des batteries Nickel-Zinc (Ni - Zn), s'assurer que la valeur du paramètre de
programmation "COMPENSATE" est déterminé en fonction du linéaire approximatif pour
l'indemnisation de la batterie Ni - Zn particulier.
30 | SAMLEX AMERICA INC.
Parameter Setup
Enter Key
ð
S E L E C T G R O U P B U L K C U R R E N T
C H A R G E C U R V E
Enter Key
ð
S E L E C T G R O U P B U L K C U R R E N T
C H A R G E C U R V E
Series Inverter/Charger).
™
Up Key x 2 times
ð
E Q U A L I Z E V O L T A G E
4 0 A 1 4 . 4 0
Up Key x 3 times
ð
F L O A T I N G V O L T A G E
4 0 A 1 3 . 5 0
Enter Key
ð
K E Y I N P A S S W O R D
V 0 0 0 0
Password 8052
See Section 4.3.1
Enter Key
ð
K E Y I N P A S S W O R D
V 0 0 0 0
Password 8052
See Section 4.3.1
APPENDIX A
ð
E Q U A L I Z E V O L T A G E
1 4 . 4 0 V
ð
F L O A T I N G V O L T A G E
1 3 . 5 0 V
Inverter/Charger
™