SamplexPower EVO-RC Owner's Manual page 25

SECTION 4 |
don't need to enter the Password again until until any key is not pressed for over 60 seconds. An example of Parameter
setting is shown at Section 4.3.1 below:
i
INFO
Password protection is considered desirable to prevent accidental/ un-intentional changes of parameter values.
4.3.1 Example of Password Activation and Changing Bulk Current Setting for EVO-2212/3012/4024
from Default Value of 40A to new value of 50A
S E L E C T G R O U P
C H A R G E C U R V E
B U L K C U R R E N T
4 0 A
K E Y I N P A S S W O R D
0 0 0 0
Password - 8052
P A S S W O R D C O R R E C T
P A S S W O R D E R R O R ! !
Parameter Setup
Starting from any of the Operating Mode Screens (shown at Fig 3.2 to 3.6), press Enter
key. Screen "SELECT GROUP, CHARGE CURVE" as shown on the left will be displayed
(PARAMETER GROUP NO.1 of Menu Map, Fig 4.1)
Press Enter key to access up to 23 PARAMETER SETUP SCREENS under PARAMETER GROUP
NO.1 "CHARGE CURVE", (Parameters are detailed at Table 4.1 and Fig 4.1)
Screen "BULK CURRENT, 40A" as shown on the left will be displayed (PARAMETER SETUP
SCREEN NO.1 of PARAMETER GROUP NO.1 "CHARGE CURVE", Fig 4.1). Default current
setting of 40A or previously set value will be displayed.
Press Enter Key to change the value of parameter BULK CURRENT.
Password consisting of 4 digits will be requested as shown in the display screen on the left.
4 digits will be displayed (with initial value 0000) with the cursor blinking on the first digit
(0) on the left (shows digit "0" and cursor "_" alternately). Use Up /Down Keys to scroll to
number 8 for the first digit "8" of the password. Momentarily press Enter Key (Short
press). Digit 8 will be entered as the first digit of the Password and the blinking curser
will automatically move to the 2
"8052" is "0", momentarily press Enter Key (Short press) to enter "0" in the second
digit. The blinking cursor will automatically move to the 3rd digit (0). Use Up /Down Keys
to scroll to number 5 for the 3rd digit "5" of the password "8052" and momentarily
press Enter Key (Short press). The blinking cursor will automatically move to the 4th
digit (0). Use Up /Down Keys to scroll to number 2 for the 4th digit "2" of the password
"8052". Now keep the Enter Key pressed continuously for longer time (3 to 4 sec) to
write the full password of 4 digits
i.e. "8052".
Screen as shown on the left flashes twice when Password is correct. (8052)
Screen as shown on the left flashes twice when Password is not correct.
digit (0) to the right. As the next digit in the Password
nd
APPENDIX A
SAMLEX AMERICA INC. | 25