Displaying the Connection Wizard
This section describes how to add connection settings by following the connection wizard.
If an error is displayed, see
Pressing the shutter button or other camera controls during configuration using the
connection wizard will close the connection wizard. Do not press the shutter button or
other controls until configuration is finished.
[
: WFT settings] is only available when [
1.
Press the 〈
2.
Select [
3.
Select [Enable].
4.
Select [Connection settings].
Troubleshooting
and check the settings.
〉 button on the camera.
: WFT settings].
28
: Multiple exposure] is set to [Disable].