Canon WFT-R10 Advanced User's Manual page 40

Specifying the Authentication for the Access Point
3.
Select the authentication.
Entering the Access Point Encryption Key
Enter the encryption key (password) specified for the access point. For details on the
specified encryption key, refer to the access point's instruction manual.
The screens displayed in steps 4 and 5 below vary depending on the authentication and
encryption specified for the access point.
Go to Setting the IP Address
the screens for steps 4 and 5.
4.
Select a key index.
Select an item and select [OK] to go to the next screen.
If you select [Open system], the [Encryption settings] screen will be
displayed. Select [None] or [WEP] on this screen.
when the [IP address set.] screen is displayed instead of
The [Key index] screen is displayed when [Shared key] and [WEP]
are selected in step 3.
Select the key index number specified for the access point.
Select [OK] to proceed to the next screen.
40