Displaying The Connection Wizard - Canon WFT-E4 Instruction Manual

Displaying the Connection Wizard

This section describes the process of following the connection instructions. If an error is
displayed, refer to "Troubleshooting" in Chapter 8 (p.79) and check the settings.
Pressing the shutter button or other camera controls during configuration by the connection
instructions will close the connection instructions. Do not press the shutter button or other
controls until configuration is finished.
On the [5] tab, set [Auto power off] to [Off]. If auto power off is activated, the connection
instructions will be closed during the configuration process.
18
Turn the camera on.
1
Display the transmitter menu.
2
On the camera, press the <7> button.
On the [5] tab, select [WFT settings] and press
<0>. [WFT settings] is added to the tab after
you attach the transmitter.
Select [Connection wizard].
3
The [Select communication method] screen is
displayed.
The <LAN> lamp starts blinking.