Displaying the Connection Wizard
This section's explanation follows the flow of the connection instructions. If an error is
displayed, see "Troubleshooting" in Chapter 10 (p.97) and check the settings.
Pressing the shutter button or other camera controls during configuration will cause the
connection instructions to close. Do not press the shutter button or other controls until
configuration is finished.
In the menu, set [Auto power off] to [Disable]. If auto power off is activated, the connection
instructions close during the configuration process.
Turn on both the camera and
1
transmitter.
Display the transmitter menu.
2
On the camera, press the <7> button.
In the menu, select [Communication settings]
and press <0>.
Select [Network settings].
3
Select [Connection wizard].
4
The [Select communication method] screen is
displayed.
The <LAN> lamp on the transmitter starts blinking.
19