Power Cord Connection; Motor Cord Connection - Nakanishi iSpeed3 Operation Manual

9 . POWER CORD CONNECTION

WARNING
Only use grounded power sources. Failure to properly ground the control unit may result in
electric shock, injury, fire and/or damage to the system components.
When connecting the power cord, make sure the Main Power Switch is turned OFF.
CAUTION
When installing the product, provide space of approximately 10 cm around the control unit for
easy access to the Air Inlet and the Power Cord.
Insert the power cord hook to the fixing power cord hook bar on the rear of the control unit. Refer to the
Fig. 15 .
Insert the female plug into the main power inlet box on the rear of the control unit. Refer to the Fig 16 .
Secure the power cord by use of power cord hook. (Refer to Fig. 17 .)
Power Cord Hook

10 . MOTOR CORD CONNECTION

CAUTION
Before connecting the motor cord, make sure the power source and control Main Power Switch ⓖ are turned OFF.
Ensure alignment pin upward.
Carefully insert the alignment pin into the alignment hole and push straight into the motor lead
port of the rear of the control unit.
Tighten the coupling nut.
11
Main Power Switch ⓖ
Fixing Power Cord
Hook Bar
Insert
Fig. 15
Push
Alignment Pin
Coupling Nut
Fig. 18
Fig. 17
Fig. 19
Main Power Inlet
Power Cord
Insert
Fig. 16
Alignment Hole