External Input/Output Control Signal Specifications - Nakanishi iSpeed3 Operation Manual

17 2 Setting Motor Rotating Direction, Motor Start /Stop, Motor Speed.
-
17 - 2 - 1 Setting Manual Mode
Set Motor Rotating Direction
Push the Motor Rotation Direction Button
Select FWD. Right hand rotation.
Select REV. Left hand rotation.
Motor Start/Stop
Push Start/Stop Button
Setting Motor Speed
Set the speed by pushing the Motor Speed Adjustment Button
Motor Speed Range is 1 , 000 - 80 , 000 min
Motor Speed Range is 1 . 000 - 60 , 000 min
The Motor speed is displayed in 100 min
17 - 2 - 2 Setting Auto Mode
All the iSpeed System functions can be controlled by Input Control Signals to Input/Output Connector A
Setting Motor Rotation Direction
Input the Motor Rotation Direction Signal to Pin No. 2 : DIR_IN.
Right hand rotation is OFF 'Open' ("FWD." LED will light).
Left hand rotation is ON 'Closed' ("REV." LED will light).
Motor Start/Stop
Input the Motor Start Signal from Pin No. 14 : START.
Motor Rotating is ON 'Closed' (START/STOP LED will light).
Motor Stop is OFF 'Open' (START/STOP LED is off).
Setting Motor Speed
Input the Motor Speed Signal to Pin No. 23 : VR
Motor Speed Range is 1 , 000 - 80 , 000 min
The Motor speed is displayed in min
17 3 Setting other Parameters
-
The following Parameters can also be preset.
Error Output Signal.
Front Panel or External Signal Speed Control during Auto Mode Operation.
Fixed Motor Rotation Speed.
Maximum Motor Speed.
Selection of External Motor Speed Signal.
External Motor Start Command Signal Method.
Selection of Motor Acceleration and Deceleration Time
Selection Emergency Operating Function.
Setting the Level of Speed Achievement.
Error History Display.
- Confirmation of Parameter -
Please refer to section 21 " SETTING OF OPERATING PARAMETERS " of this manual for details.

18 . EXTERNAL INPUT/OUTPUT CONTROL SIGNAL SPECIFICATIONS

18 - 1 . Input/Output connector A
Input/Output connector A
WARNING
Do not connect any circuit other than SELV ( 24 VDC)(Safety Extra Low Voltage) to the
External Input/Output connector A
CAUTION
Input/Output connector A
PIN
If No. 16 is connected, the control unit will be damaged.
17
.
and START LED will illuminate.
- 1
. (BM 319 /BM 319 F/BM 319 FC, BM 320 /BM 320 F)
- 1
. (BM 322 /BM 322 FR/BM 322 FL, BM 325 )
- 1
. 800 = 80 , 000 min
- 1
- 1 . 800 equals 80 , 000 min
, This will cause I/O board damage in the control unit.
DO NOT USE PIN
.
- 1 .
- 1
No. 16 .